Futuro FuturoFolioDesigner Range HoodInstallation & User’s Manual
Weight: 55 lbs. (25 kg)Must be attached toload-bearing component(joist/frame/plywood),NOT to bare sheetrock.Overall Dimensions20.7”20”0.4”4.1”6”33.5”4
Ducted installation - vertical blower output11.3”18”Mounting, Part I:It is recommended for the center of the range hoodto be approximately 26” - 28” a
Backdraft Damper InstallationA backdraft damper is supplied with the range hood.For DUCTED installation, it’s strongly recommended to DISCARD this dam
Ducted installation - rear (horizontal) blower outputBlower Motor Removal11.3”18”Mounting, Part I:It is recommended for the center of the range hoodto
Blower Motor RepositioningRemove the blower, remove the knock-out plate (1), and re-install the blower in new direction,repeating the steps described
Metal Mesh FiltersFor ducted AND ductless installationCarbon (charcoal) FiltersONLY for DUCTLESS installationFilters InstallationBottom Panel Operatio
The electric circuit to which the hood is to be connectedmust be: * In compliance with local electrical standards, * Properly grounded, * Ded
The duct (air pipe) must have:* A diameter of 6” throughout its entire run, including the end-cap (roof or wall cap).* A slight slope downward in hori
Comments to this Manuals